Rigging (Heavy Duty)

/
0 Comments

  • Sanding the ball joints to a rough finish helps keep them tight and grippy
  • Doubling up the side portions of the ball joints makes them much less likely to deform under pressure and therefore much tighter
  • Replacing the desk clamp with an old chemistry retort stand, much more stable, slightly harder to manoeuvre  but will hold much more weight.
Problems now seem to be solved...

   


About Richard Whillock

A beardy bloke who is pleased by the production of puppets and the set-up of stop-motion stuffs. A love for the scruffy, the textured and the original.

You may also like

No comments:

Popular Posts

  • Puppet Progress Shots
     Just a collection of shot from today's progress on the full-body armature/puppet, have to leave it mid-foaming up for tonight....
  • Latex Layering
    Initial layers of standard latex used to build up the detail areas such as eyelids etc Colouring the latex: a good glug of water, plenty of...
  • Francisco Herrera
    I first stumbled across this character designer and comic artist when I was given a free book by accident from a book shop. I'm sure gla...
  • Being Dead
    Well, here it is, the final completed film! If you go to Vimeo , you can watch it in HD. Thank-you to everyone who helped in one wa...
  • Throw the switch Igor!
    Looking at a few references of laboratories and mad scientists (very much the movie-versions) And so I've started to add details to ...